Independent reviews of pressure, water-bath and steam canners, checked against USDA canning guidanceHow we make money
Review

All American 15.5-Quart Pressure Canner (915) Review

All American's machined metal-to-metal seal, with no gasket to replace, in a size that fits under a range hood.

The All American 915 gives you the gasketless metal-to-metal seal and rocking weight in a compact size, about $400 for seven quarts or 10 pints.

Updated November 16, 2026 · By the editors of Home Canning Report · We earn from qualifying purchases

Price
About $400
Holds
7 quarts or 10 pints
Control
Weight and dial gauge
Heat
Gas, coil (not induction)

Good

  • No gasket to buy or replace
  • Weight regulator needs no yearly testing
  • Compact enough for small kitchens
  • Made in Wisconsin

Not so good

  • Only 10 pints per load
  • Heavy and slow to heat and cool
  • About twice the price of a Presto
  • Not for induction

Who it's for

Buy it if you want a canner that lasts decades with no gasket to replace, and you mostly can quarts or don't have room for a taller pot.

Skip it if you can lots of pints (the 921 double-stacks 18) or want the lowest price (the Presto 23-Quart is half as much).

How All Americans are built

All American canners are made by Wisconsin Aluminum Foundry in Manitowoc, Wisconsin, from thick cast aluminum. The lid and pot are machined so they seal metal to metal, held down by wing-nut clamps around the rim. There's no rubber gasket to replace; you wipe a thin film of petroleum jelly or olive oil on the beveled edge so the lid seats and comes off easily.

Each one has two pressure controls. The regulator weight on the vent pipe rocks at 5, 10 or 15 pounds and is what you go by. The geared dial gauge is a reference. Because the weight controls pressure, you don't need yearly gauge testing to can safely, though a dial that disagrees with the weight is worth checking.

Is 15.5 quarts enough?

For quarts, yes: seven fit, the same as the bigger 921. Pints are where it falls behind: the 915 isn't tall enough for a second layer, so it holds 10 pints to the 921's 18. If most of your canning is chicken, stock and tomatoes in quarts, the 915 saves height and weight.

The trade-offs

Thick metal means slow heating and slow cooling, so a full cycle takes longer than with a Presto. The lid is heavy and the clamps take a minute to tighten evenly. The weighted gauge only does 5, 10 or 15 pounds, so above 1,000 feet you process at 15 pounds rather than the 11 to 14 a dial gauge would use. That's safe; it just runs hotter than needed, which can soften some vegetables.

All Americans are aluminum, so they don't work on induction. For glass-top ranges, check your range manual: a loaded 915 is heavy, and some range makers limit pot weight.

Questions

Does the All American 915 need a gasket?

No. The lid seals metal to metal. A thin film of petroleum jelly or olive oil on the beveled edge helps it seat and release.

Do I need to test the dial on an All American?

You go by the weighted regulator, which doesn't need testing. The dial is a reference; if it disagrees with the weight, have it checked.

Keep reading