Independent reviews of pressure, water-bath and steam canners, checked against USDA canning guidanceHow we make money
Guide

How to Use a Pressure Canner, Step by Step

Venting, timing and cooling are where most mistakes happen. Here's the sequence USDA and extension services teach.

Put 2 to 3 inches of hot water in the canner, load jars on the rack, lock the lid, vent steam for 10 minutes, bring it to the pressure for your altitude, time the process, then let it return to zero on its own and wait 10 more minutes before opening.

Updated November 16, 2026 · By the editors of Home Canning Report · We earn from qualifying purchases

Steps

  1. Check the canner. Make sure the vent pipe is clear, the sealing ring is soft and the dial gauge was tested this year.
  2. Add water. Put the rack in and add 2 to 3 inches of water, unless your canner's manual says otherwise. Heat it to about 180°F for hot-packed food or 140°F for raw-packed.
  3. Load jars. Fill jars with a tested recipe, leave the right headspace, wipe rims and apply lids. Set jars on the rack with a jar lifter.
  4. Lock and vent. Lock the lid with the weight off (or petcock open). Heat on high until steam flows in a steady funnel, then let it vent for 10 full minutes.
  5. Pressurize. Put the weight on or close the petcock. Let pressure build to the level for your altitude.
  6. Time it. Start timing when the dial reads the right pressure or the weight starts rocking as described in your manual. Adjust heat to hold it steady. If pressure drops below the target, bring it back up and start the full time over.
  7. Cool naturally. Turn off the heat and let the canner cool until the pressure is zero. Don't run water over it or remove the weight early.
  8. Open carefully. Once at zero, remove the weight or open the petcock, wait 10 minutes, then unlock the lid and tilt it away from you.
  9. Rest and check. Lift jars out upright onto a towel, an inch apart. Leave them 12 to 24 hours, then check seals.
Safety

Never open a canner that's still under pressure, and never leave a pressurized canner unattended.

Electric canners

Electric canners like the Presto Precise vent, time and cool automatically. Follow their manual rather than these steps.

Questions

Why vent for 10 minutes?

Air trapped in the canner lowers the temperature at a given pressure. Venting pushes it out so the gauge reflects the real temperature.

Why can't I cool the canner faster?

Fast cooling causes liquid loss and failed seals, and the cool-down is part of the tested process.

How much water goes in a pressure canner?

Usually 2 to 3 inches, unless your canner's manual says otherwise.

Keep reading